UAB "Atomis"
Sales:
GSM: +370 616 16161
Technical Support:
Technical Support for Speedstop & other emulators ONLY!
GSM: +37069255738 +Viber | Daniel | |||||||||||||
| Hi there i have a bmw m3 2001, i take the inmo out make all the conection i use a power supply to feed the carprog, then i read the inmo work fine, wen i go to test a key with the original key there a problem say not transponder key, then use a ney key and say not a transpoder key or not a bmw key the key need adaptation put in the ign. for 5sec. then i cut the key puty in the ign for 5 sec. then try to write the key and the same trouble not a transponder key or transponder not respond, the key i use is the key with remote all in one unit, i try 11 keys i have and all is the same trouble, the one of the key try to write a apears to write then wen try to verify gave me and error not a trasponder key, all the key are new they came in to put in slot i have slot 5,6 7. and none work please i apreciate the help. ![]() ![]() p.s. i have picture of the key i use but i don,t no haw i send to you to see the key |
|||||||||||||
Quote ![]() |
|||||||||||||
Reply |
| raimis | 2007-09-17 09:22:04 | |||
| hi, be sure that key orientation is vertical do you have any empty PCF7935 or PCF7930 transponder bmw keys with remote inside not supported at moment task should be finished today key adaptation procedure (5sec ignition on) is required for mathed keys only this meens that key should be already programmed with EWS data to put any used key to new state - unselect suitable check box near key "USED" (and write changes to EWS) then switch ignition on for 5sec to perform key adaptation regards Raimis |
||||
Quote![]() |
||||
| raimis | 2007-09-18 11:50:05 | |||
| update ready - connect update server to download | ||||
Quote![]() |
||||
Reply |